The android app crashes after 5 minutes
-
Good morning, I have app for Android. I connected bluetooth receiver and ntrip server. Everything works very well and gives the correction. The only problem is the application disconnects the transfer every 5 minutes. I then have to press the play button again and it still works fine. It's not a big problem but it's annoying. Can anything be done about it?
-
@andy-bachmacka-1958 Hi, If you have no active subscription, the app should show you a subscription prompt every 100kb and stop the session.
If it actually crashes, please tell me your phone model and android version, I'll check the log.
-
@ilyavialkov please kindly clarify/confirm that the ycserver app is not free to use but requires payment, right?
-
@touritailglm yes. it's not free.
-
@ilyavialkov how to pay, I can't find a link or anything anywhere
-
@cecomir88 when you reach the 100kb limit, It should show the payment prompt.
-
@ilyavialkov Hello,
the case is the following, I have a GNSS receiver that I want to place on a point with known coordinates and through a local connection between the receiver and its controller via bluetooth or serial to output NTRIP data such as IP, port, access point and so on to set to another device in the case of a drone remote. The whole problem is that at the place I want to fly in RTK mode, there is no coverage of any mobile operator, that is, there is no coverage or internet. I installed the YCserver app on in the GNSS receiver controller, then connected the receiver to the controller, ran the app and created a source (bluetooth) then destination NTRIP I run and it gives me destination error. -
What could be the problem, I think I'm messing with the Host setting
-
I am using android 8
-
@cecomir88 If you have no coverage in your area, why are you gonna use NTRIP? Please post a screenshot of destination error.
